Bore Reticulation in Quinns Rocks
A bore is a fantastic idea. You use the underground water supply, don’t pay for water that gets used by the bore and you get to water more often. Recently I was doing a job by the beach in Quinns
Hot Tip For DIY Retic Installers
I started doing retic as a DIY about 4 years ago and learnt this one the hard way. When you need to place sprinkers along the kerb by the roadside always dig your trench approx 1 m in from the
Low Water Pressure in Jindowie?
I’ve only done a couple of jobs in the new Yanchep estate of Jindowie, but what is most noticeable about this area is the very low water pressure. I have no idea why the pressure is so poor, but I
Should I Use MP Rotators in My Reticulation
Short answer – if you can YES! I am a fan of MP rotators because they allow you to water more effectively. The rotators spray ‘fingers’ of water and can water up to approx 8 metres. Because they distribute
My Reticulation Goes Through the Whole Cycle and Then Starts Over
I have heard of this happening a couple of times. The whole program runs through as normal and then starts over and repeats itself on and on and on… not good. Clearly the solenoid valves are opening and shutting and
Setting up a Reticulation Controller for a Bore
The big difference between setting up a controller for a bore and a system of mains is that the ‘master’ terminal actually serves to trigger the pump and a relay must be installed between controller and pump to get it
South of the River Reticulation
Brighton Reticulation serves the northern suburbs of Perth from Two Rocks down to Scarborough and as far east as Beechboro, but rarely do we travel beyond. So for jobs in the south and the ‘east’ of Perth we recommend two
